Section checks. The bar cannot be checked

This can be due to a couple of reasons:

  • There are simple loadcases whose combination is not contemplated by the default combinations table. This usually occurs when two dead load loadcases have been defined. Therefore, the combination must be created or reduce the number of dead loadcases to 1.
  • The bar is a concrete or generic bar, in which case the program only provides the forces of the bar and does not check the section.

Top Top Top Section Go back go back

Top Top

©CYPE Ingenieros, S.A. - Avda. Eusebio Sempere, 5 - 03003 ALICANTE. Spain
Tel. USA (+1) 202 569 8902 // UK (+44) 20 3608 1448 // Spain (+34) 965 922 550 - Fax (+34) 965 124 950
Home | CYPE | Legal Aspects | Products | Versions | Downloads | Contact us
Bulgarian | French | Italian | Portuguese | Spanish | Spanish (Mexico) | Other dealerships